This board is helpful for connecting digital systems (like a 5V microcontroller) to a high-voltage or a noisy system. This board electrically isolates a controller from the high-power system by use of an opto-isolator IC. This IC has four LEDs and four photodiodes built-in.
This board will isolate the systems, creating a type of electrical noise barrier between devices and this board uses the TLP281 opto-isolator and discrete transistors to correct the logic. This board can be used in heavy- noise environments like motor driving application to isolate the signal between the driver and the microcontroller. Maximum voltage is 24V.
Features:
Use of low level control high levelSuch as the use of single chip microcomputer 3V or 5V voltage 9V or 12V voltage controlHVCC maximum not more than 24VOutlet OUT1 / OUT2 / OUT3 / OUT4 output current is equal to the largest HVCC / 5.1KMaximum absorption current 500mADimension: 25mm x 24mmWeight: 5 gToshiba TLP281 chipMaximum Voltage 24V
Input and Output Instruction:
Input: IN1 / IN2 / IN3 / IN4, then the microcontroller or Arduino IO port, GND and the Arduino development board connected to the GND. IN1 / IN2 / IN3 / IN4 controls OUT1 / OUT2 / OUT3 / OUT4, respectively.
Output: OUT1 / OUT2 / OUT3 / OUT4Output: HVCC: Connect the controlled high voltage positive, HGND connected to the controlled high voltage negative
Use: When IN1 is high, the corresponding OUT1 voltage is equal to HVCC, when IN1 is low, the OUT1 voltage is equal to HGND.
Package Includes:
1 x 4-Channel Opto-isolator IC Module for Arduino compatible High and Low level Expansion Board